Waxing Career of DSP for 2 wax rolls 100gr, is practical and allows the wax to be maintained at a constant temperature during waxing. It has a support base for easy placement.
Instructions for use
• Before using it, make sure the skin is clean.
• Place the roll in the appropriate slot of the heating device and plug the device into the socket.
• If the wax is not fluid enough, you can reheat it, while if it is hotter than necessary, let it cool down a bit.
• During waxing, periodically place the roll in the device to keep the wax fluid.
Caution
• Always check the temperature of the product before applying it by applying a small amount to the back of your wrist.
• Do not overheat the wax as it reduces its effectiveness and there is a risk of minor burns.
• If any hot product falls on your skin, immediately rinse it off with plenty of cool water until it is completely dissolved.
Application
• Apply a very thin layer of wax in the direction of hair growth using the roll.
• Place one of the strips on top of this thin layer and gently press with your hand in the direction of hair growth to ensure good adhesion.
• Leave the bottom part of the strip free (2cm) for easy removal without dirtying your hands.
• You can use the same strip as long as it sticks well to the skin.
• Hold the skin taut and remove the strip by pulling it abruptly, parallel to the surface of the skin and opposite to the direction of hair growth.
• Use a cleanser to remove any wax residue that may remain on the device.
After use
• If there is any leftover wax, store the roll in a horizontal position, in a cool, dry place until the next use.